Measurement Range:

Impedance

50Ω,75Ω（1）

Test port connector

N-type, female

Number of test ports

2

Frequency range

300kHz to 8GHz

Full CW frequency accuracy

Frequency resolution

±5×10-6

1Hz

Number of measurement points

2 to 10001

Measurement bandwidths

1Hz to 30kHz (with 1/1.5/2/3/5/7 steps)

Dynamic range (IF bandwidth 10 Hz)

130dB, typ.135dB

(1)use 75Ωconnectors via adapters

Measurement Speed:

Measurement time per point

100μs

Source to receiver port switchover time

＜10ms

Typical cycle times versus number of

measurement points（IFBW 30kHz）

51

201

401

1601

Uncorrected（Start 300 kHz, stop 10 MHz）

13.1ms

51.3ms

102.3ms

408.3ms

Full two-port calibration（Start 300 kHz, stop 10

MHz）

45.5ms

122.0ms

230.5ms

840.5ms

Uncorrected（Start 10 MHz, stop 8 GHz）

6.5ms

21.1ms

40.5ms

157.7ms

Full two-port calibration（Start 10 MHz, stop 8

GHz）

32.4ms

61.7ms

100.3ms

333.0ms

Measurement Accuracy:

Accuracy of transmission measurements (magnitude / phase)

+5dB to +15dB

0.2dB/2º

-50dB to +5dB

0.1dB/1º

-70dB to -50dB

0.2dB/2º

-90dB to -70dB

1.0dB/6º

Accuracy of reflection measurements (magnitude / phase)

-15dB to 0dB

0.4dB/3º

-25dB to -15dB

1.0dB/6º

-35dB to -25dB

3.0dB/20º

Trace stability

Trace noise magnitude (IF bandwidth 3 kHz)

1mdB rms

Temperature dependence (per one degree of

temperature variation)

0.02dB

Effective System Data1:

Effective directivity

45 dB

Effective source match

40 dB

Effective load match

45 dB

1 applies over the temperature range of 23°C ± 5 °C after 40 minutes of warming-up, with less than

1 °C deviation from the full two-port calibration temperature, at output power of -5 dBm, and IF

bandwidth 10 Hz.

Test Port Output:

Match (without system error correction)

18 dB

Power range

300 kHz to 6.0 GHz

6.0 GHz to 8.0 GHz

-60dBm to +10dBm

-60dBm to +5dBm

Power accuracy

±1.5dB

Power resolution

0.05dB

Harmonics distortion

＜-25dBc

Non harmonics distortion

＜-30dBc

Test Port Input:

Match (without system error correction)

18 dB

Damage level

+26dBm

Damage DC voltage

+35V

Noise level (IF bandwidth 10 Hz)

＜-125dBm